For all your GLASS REQUIREMENTS including
SPLASHBACKS, SHOWERSCREENS and MIRRORS . We custom make all our products using only quality materials and licensed trades. With over 25 years experience in the glass and building...
"I'm just after an approximate cost for a piece of glass to fit my dining table. i don't have the exact measurements but the table is a standard 6 seated. also need a smaller piece that would be 1m squared"
Julie from Noarlunga Downs was connected.
"I need a mirrored glass door with backing cut to fit above a power point."
Kloe from Port Noarlunga was connected.
"I need 1 29(l)x38.5(h) cm and 1 28.5(l)x38.5(h)of glass cut out. these will be lids for my fish tank, i would like to have 3cm cut off 1corner of each piece of glass"
Kylie from Hackham was connected.
"We need a glass shower screen cut to fit over our bath."
Suzanne from O'Sullivan Beach was connected.
"Cut a shower screen to size from 1200mm to 725 & 1125mm"
Shae from Morphett Vale was connected.
"I need our pet door installed so i need the glass cut for installation."
Jared from Morphett Vale was connected.
"A 670mm by 670mm piece of glass cut into 2. 475/320mm panes the glass is 6mm thick"
John from Woodcroft was connected.
"Heatproof glass replaced and installed in door of combustion heater,size is approx 460x260mm"
Anthony from Morphett Vale was connected.
"I have a dining table that has 3 glass inserts. the glass is too big for the slots in the table (the table was cut at the factory). table is now outside of warranty. i have approached the retailer and they will pay for the glass to be cut to size. each piece of glass is approx 280mm x 280mm. and only needs about 1mm taken off one of the sides on each piece."
Tracy from Lonsdale was connected.
"One 530 mm x 990 mm sheet of glass to be used as a coffee table supported at the edges only.
the glass will need to be toughened with a bevelled edge."
Browse the local directory for Glass Cutting in States and Capital Cities